8
9
DOWNROD STYLE FAN MOUNTING
CLOSEMOUNT STYLE FAN MOUNTING
3. Loosen the two set screws from the yoke. Slip
downrod assembly (E) into yoke, aligning holes
in downrod assembly (E) and yoke. Insert the
pin through yoke and downrod assembly (E),
then insert clip into pin until it snaps into place.
Tighten set screws. Slide the yoke cover (D)
down over the motor assembly (F).
2. Remove every other screw from the top of the
motor assembly (E) -- for a total of 3 screws --
and save.
4. Install hanger ball on the top of downrod assembly
(E) into mounting bracket (A) opening. Rotate fan
until slot on hanger ball engages the tab on the
mounting bracket (A).
3. Place the rubber gasket (FF) over the remaining
screws on motor assembly (F). Pull wires from
motor assembly (F) through hole in canopy
(B), and attach canopy (B) using the three
screws previously removed. Tighten the screws
securely.
1. Remove the canopy cover (C) from the bottom
of the canopy (B).
4. Temporarily hang the canopy (B) onto the hook
on the mounting bracket (A) using one of the
non-slotted holes in the canopy (B). This will
allow for hands-free wiring.
H
F
2
1
DANGER:
Be careful when aligning the tab
to the slot! If not fully engaged, there is a
possibility of fan falling, which may result in
serious injury or death.
Proceed to
WIRING
on page 10.
CLOSEMOUNT STYLE FAN MOUNTING
H
Hardware Used
FF
Rubber Gasket
x 1
H
B
FF
4
Tab
Slot
A
E
3
H
B
FF
3
4
Clip
Pin
Set screw
E
D
F
Yoke
C
B
B
F
FF
A
B
Hook
Lowes.com/harborbreeze
Lowes.com/harborbreeze
