ASSEMBLY INSTRUCTIONS
1. Attach mounting plate (A) to outlet box (not
included) using two screws (not included).
Securely tighten two outlet box screws. Pull
black, white, and grounded wires out of outlet
box and through the hole in the mounting
plate (A).
2. Place trim ring (C) over canopy, and lay it on
fan motor (B).
3. Loosen two preassembled screws across from
each other on the mounting plate (A). Remove
and save remaining two preassembled
screws. Hang fan motor (B) on mounting plate
(A) hook using one of the non-slotted holes in
the canopy.
7
6
A
Outlet
box
Screw
1
Ground/
Green
White
Black
Green/
Grounded
Black
Black White Green
Outlet box
Receiver
White
Supply
Circuit
4
AA
5
B
A
Screw
6
B
C
Canopy
2
A
B
Canopy
Screw
Hook
3
ASSEMBLY INSTRUCTIONS
6. Align keyhole slots on the fan motor (B) with
the protruding screw heads on the mounting
plate (A). Lift the fan motor (B) up to the
mounting plate (A), making sure not to break
any wire connections. Rotate the fan motor
(B) clockwise until the screw heads fully
engage into keyhole slots. Insert the previously
removed screws (Step 3, page 6) and securely
tighten all the screws.
IMPORTANT:
Do NOT use this fan with a
dimmer switch or variable speed wall control.
Using a dimmer switch or variable speed wall
control will damage the fan.
ON
ON / OFF
switch
NO Variable
speed wall
control
NO Dimmer
switch
4. Connect the
BLACK
wire from the fan to
the
BLACK
wire from the ceiling. Connect
the
WHITE
wire from the fan, to the
WHITE
wire from the ceiling. Connect all
GROUND
(GREEN)
wires from the fan together to the
GREEN/BARE
wire from ceiling. Connecting
the
GREEN/GROUND
wires is conducive to
receive the signal of the remote control.
NOTE:
The
BLACK
wire is the hot power for the
fan and light kit. The
WHITE
wire is common for
fan and light kit.
GREEN
wire is the ground wire.
lf the household wires are different colors than
referred to above, stop immediately and consult a
professional electrician to determine proper wiring.
5. Twist wire ends together and screw wire
connectors (AA) on in a clockwise direction.
Tape wire connectors (AA) and wires together
with electrical tape (not included).
Hardware Used
x 3
Wire Connector
AA
