User Manual
1. AC Cable -
Standard cable for use with standard voltages from AC wall outlets. It is grounded and should never have the
ground pin removed for any reason.
2. Speaker Out -
1/4”, 2-conductor speaker outputs. Each one is rated for an 8 Ohm minimum impedance. Total minimum load
for the amplifier is 4 Ohms. You may connect one 4 Ohm, one 8 Ohm, or two 8 Ohm speaker cabinets. Do not go below the rated
minimum impedance.
3. Line Out -
1/4”, 2-conductor line level output. The impedance is 1k Ohm @ -10 dBv. It is used to connect the HA80 to either
an additional power amplifier or an external recording device. This line level signal comes out after the master EQ section and
before the power amp.
4. Aux In -
RCA jacks for playing an MP3 Player, CD player or other line level source through the system. The impedance is 10k
Ohms @ -10 dBv. Aux volume on front panel (8) controls the level of this input. Stereo input is summed internally for mono playback
through the system.
5. Aux Out -
RCA jacks for hooking up a stereo recording device to record directly from the mixer. The signal is taken from the
pre-master section, so it does not include the master tone section, the delay effect, or the Aux In signal. The impedance is
1k Ohm @ -10 dBv.
1
Back Panel
2
3
4 5
4
