HappyJapan HCD3, Инструкция

Страница: 236 / 251

-D2 -155
24-2
ERRORS AND WHAT TO DO
24_2 NC13
. o N
y a l p s i D r o rr E s n o it u l o S e g a P
p g
021
022
Needle move Motor for needle bar selection unit has
stopped partway through its path.
No movement due to malfunction of
thread take-up lever or trouble of
position-detecting circuit board
After fixing malfunction of needle and
thread take-up lever, turn needle bar
selector shaft with wrench to have it set
at center of fixed position (range within
which needle bar selector doesn't move)
Fig. 1
024 Needle center Needle bar stop position is off-center;
needle bar stop position is out of place.
Turn needle bar selector with 3mm hex
wrench to have it set at center of fixed
position (scope within which needle bar
selector doesn't move).
Fig. 1
025 Needle over Needle # out of range of actual needles
on given machine.
026 Needle differ Needle # differs between
030 Slow mismatch Improper speed adjustment at low
speed. Speed does not decrease below
100rpm at low speed.
Re-initialize machine system and speed. 25-1
25-2
050 C point Main shaft is stopped in a position other
than "C" point
See Fig. 2 below. 24-5
051 L sensor Timing detection board fault, or marred
photo-sensor. Malfunction of "Lowest
needle position" sensor [PH2] on
detection circuit board.
Improper adjustment of slit plate.
Check to see if photo sensor is clean or if
the slit plate contacts sensor.
Re-initialize machine system and speed.
25-1
25-2
052 C sensor Timing board detection fault, or marred
photo-sensor. Malfunction of "Color
change position" sensor [PH1] on timing
detection circuit board.
Improper adjustment of slit plate.
060 X limit Frame/pantograph has moved beyond
sewing area along X-axis.
Return frame within sewing area using
the frame movement keys on the control
boxl.
Check pattern size and center mark to
ensure that it is within size range of
selected hoop and also properly
centered.
061 Y limit Frame/pantograph has moved beyond
sewing area along Y-axis.
063 Drive Setup During embroidery, preparation for frame
movement did not complete within
predetermined time.
Malfunction of "Lowest needle position"
sensor on detection circuit board,
Improper adjustment. Re-initialize
machine speed. If this condition occurs
frequently, contact your Dealer.
25-2
064 X Center sens. Trouble with X-Carriage sensor,
Improper position adjustment, sensor
relay board fault, cable fault.
Contact your Dealer.
065 Y Center sens. Trouble with Y-Carriage sensor,
Improper position adjustment, sensor
relay board fault, cable fault.
066 Frame drive During embroidery, frame movement did
not complete within predetermined
moving time.
If this condition occurs frequently, contact
your Dealer.
Fig. 1
Situational
position
Turn the needle bar
selection knob to the
moving head
situational position.