hapco X-20, Руководство пользователя

Страница: 9 / 13

9
Using The X - 20
Caution! : Items may be hot when removed!
WARNING
: DO NOT OPEN DOOR UNTIL PRESSURE HAS BEEN RELEASED!
6. When de - mold time is reached, slowly relieve pressure from
the tank by turning the valve back to the open position.
EAR PROTECTION RECOMMENDED!
8. Open the door and remove the cured items from the unit.
7. Once pressure has been fully relieved, loosen the swing
clamps using an adjustable wrench.
NOTICE: Operating the X - 20 with both heat and pressure causes expansion and contraction
of sealing surfaces throughout the chamber. Under these conditions, it is normal for the tank
to lose some pressure over an extended time period. For typical resin curing applications, it is
only necessary to maintain pressure until the material has reached it ’ s gel state. In situations
where constant pressure must be maintained for the entire cure cycle, we recommend using a
pressure regulator and leaving the air hose attached to the chamber.