installation & connection
18_
installation & connection
POWERING AND NETWORKING
Connect the HPoE injector with the HPoE port of the camera.
Switch
SFP Port
Switch
SFP module
External internet
OR
SFP HPoE injector
J
`
The product cannot be used at -35°C or below ambient temperature.
`
The product may not be defrosted depending on the installation area at -35°C.
`
After the product is left alone under a low temperature environment, it will take up to 3 hours to normally operate.
`
If the product is turned on after being exposed to -20°C or below environment for some time, reset the time.
`
Use the provided SFP HPoE injector when connecting power and network.
`
Use only either one of network cable or fiber optic cable for connection.
Network Cable Specification
Item
Contents
Remark
Connector
RJ45 (10/100/1000BASE-T)
Ethernet
10/100/1000BASE-T
To operate with 1000BASE-T, a cable of
UTP-6 or higher should be used for the
Giga hub.
Cable
Category 6
Max Distance
100 m
DC Resistance ≤ 0.125 Ω/m
HPoE Support
HPoE
M
`
Use an STP cable to increase the protection from thunderstroke damage.
SFP port Specification
Support SFP Voltage
3.3 V Typical
Support SFP Current
300 mA Max.
Support SFP Cage
Standard mini-SFP Cage(for 6.5 mm pitch SFP)
Support SFP Port Type
LC Type
Required SFP Speed
1250 Mbps(For 1000 Mbps Ethernet)
Required SFP’s BER(Bit Error Rate)
Max 10
-12
Transmission Method(Optical)
Mode Depends on SFP Module
Optical Mode(Long/Short Wave)
Mode Depends on SFP Module
Cable Insertion Loss(dB)
Mode Depends on SFP Module
J
`
The connection/disconnection of the SFP module must be made only after the HPoE injector is turned off.
`
A kink in the optical cable may disrupt the connection for communication.
`
Do not directly look at the optical cable. It can damage your eyes.
