Hanwha Techwin Wisenet TNM-3620TDY, Руководство пользователя

Страница: 8 / 22

installation & connection
8_
installation & connection
installation & connection
INSERTING/REMOVING A MICRO SD CARD
Remove Micro SD card cover
Using the Torx L wrench, unscrew a screw that fastens the dust-resistant cover of the Micro SD card slot,
and then remove the cover so you can insert the Micro SD card.
Inserting a Micro SD card
Insert a Micro SD card in the direction of the arrow as shown in the figure below.
J
`
Before installing the camera, the Micro SD card should be inserted while the power source and the body are separated.
`
Do not forcefully insert it in the reverse direction. It might damage your Micro SD card and your product.
`
When it rains or the humidity is high, insertion or ejection of a Micro SD card is not recommended.
`
When installing/removing the Micro SD card, make sure you put the product body on a flat ground before working on it in order
to prevent accidents due to loss or drop of any parts.
Removing a Micro SD card
Gently press down on the exposed end of the Micro SD card as shown in the figure below to eject the Micro
SD card from the slot.
J ` Before removing the Micro SD card, in < Setup ( ) >-< Event >-< Storage >, set the device to < Off > and press the [ Apply ]
button and turn the camera off.
`
If you do not and turn off the camera or remove the Micro SD card that contains data from the product, the data may be lost
or damaged.