Hanwell MS1000, Руководство по установке

Страница: 9 / 34

MS1000 Control System
Installation Guide
hanwell.com
Page 7 of 30 GD6063-1
Figure 3 – General System Schematic
2.2.1 Controllers/Processors
The CR2 and SR2 Controllers both provide an interface/controls for the MS1000 Control
System in addition to their other functions as outlined in Sections 2.2.1.1 and Error! Reference
source not found. below.
2.2.1.1 Hanwell CR3
The CR3 Controller receives and processes data signals from Hanwell radio and wired
sensors and is designed for continuous monitoring of an entire system.

Received data is then logged and stored, pending transfer to a PC for analysis and
archival storage.

The CR3 also signals alarm conditions via the front panel LEDs (should any sensor
measure above or below individual pre-set levels).

Although the CR3 Controller has an extensive memory capacity, it is intended that the
data is transferred to a PC for detailed interpretation and permanent storage. This can
be done automatically or manually, at any time.

A built in GSM modem for remote communications is also available.