Hanway STM125 2019, Руководство по эксплуатации

Страница: 12 / 43

Functions of Controllers
9
RPM Lattices RPM Lattices
0 0 6400~7000 10
100~1600 1 7100~7700 11
1700~2000 2 7800~8400 12
2100~2400 3 8500~9100 13
2500~2800 4 9200~9800 14
2900~3500 5 9900~10500 15
3600~4200 6 10600~10900 16
4300~4900 7 11000~11300 17
5000~5600 8 11400~11700 18
5700~6300 9 11800~ 18+OVER BOOST
7
Battery control display
When the battery voltage becomes too low, the control display of the
battery will begin to flash. The symbol will stop flashing as soon as the
voltage rises above the minimum voltage 11.5V.
8
Digital clock
In the cockpit there is a digital clock.
9
Multifunction display
This display shows several functions. Press and release the button
“
M
”
to change between the information: Total distance counter, distance
counter, average speed and travel time / lap time. The display of the
distance counter, average speed and travel time / lap time can reset by
pressing and holding the button
“
S
”
.
*Total distance counter (ODO)
The counter displays the total distance covered by the vehicle in
kilometers or miles.
*Distance counter (TRIP)
The display indicates the distance travelled since the last reset.
Set up:
1.To activate the setup mode, press the button
“S”
until the time
(hour) begins to flash.
2. Now set the hour even with the button
“S”
and confirm your
entry with the button
“M”
.
3. Now set the minutes with the button
“S”
and confirm with the
Button
“M”
again.