Application measurement
EN
HBT3000 series user manual
Copyright © Qingdao Hantek Electronic Co., LTD
30
Press this soft key to set the Limits and Percent of the voltage.
Select the Limits, set the Max(V) and Min(V).
Select the Percent, set the Datum(V) and Percent (%).
Note:
if there is no command setting in the comparator interface for more
than 30 seconds, the instrument will automatically jump to the measurement
display interface.
After the comparator function is turned on, the comparator interface
parameters cannot be modified.
After the comparator function is turned on, operations that affect
measurement will be prohibited. Prohibited operations include the following:
All settings in the MEA interface are invalid, and clicking the SAVE, LOAD, and
0ADJ buttons is invalid.
6.2.2
Setting the Limits and Percent
Click on the
Res
on the comparator page to set the parameters of the resistor
comparator; Click on the
Vol
on the comparator page to set the voltage
comparator parameters. There are two modes for parameter settings: Limits and
Percent, with the default being the Limits mode.
Figure 6-8 Set the upper and lower limits of resistance
Press this soft key to set the Limits and Percent.
Select the Limits, set the Max and Min.
Select the Percent, set the Datum and Percent.
The steps for setting Max ,Min, Datum, and Percent are the same, using setting
Datum as an example for explanation.
On the resistance ratio interface, click on the
Datum (m
Ω
)
and a numeric keypad
will pop up, as shown in the following figure.
