Hanshen TIG200P, Руководство по эксплуатации

Страница: 15 / 17

14
List 8
Troubles Possible causes Eliminate methods
Fun does not work after
turning on the power switch Power does not exist Check input power
Power switch is broken Change power switch
Disconnection inside machine Check inside connecting
The fun is broken
Change fun
Trouble of
arc-igniting
No voice of
HF
discharging
exists inside
machine Torch switch or “arc control”
jack is broken or its
connection is no good Check the condition of switch or
jack and its connection
220V/125V transformer is
disconnected or broken Check transformer and its
connecting
Can not close J2(4123) relay Check relay
High voltage box or capacitor
is broken Check High voltage box or
capacitor
Voice of HF
discharging
exists inside
machine Overheat protection or
overflow protection Turn off the mcahine for a few
minutes and retry
Tungsten electrode is far
away from workpiece Keep the distance of 2-3mm
between tungsten electrode and
workpiece
Tungsten electrode is not
sharp or is broken Sharpen tungsten electrode
Tungsten electrode is bad
fixed or its quality is bad Refix or change good tungsten
electrode
Welding current is too low or
workpiece is too dirty Enlarge current or clean
workpiece
Discharging clearance of Arc
ignition unit is dirty Clean clearance with sand paper
or
alcohol
Output rapid diode is broken Change diode
HF can not be turned off Torch switch or arc control
wire is short- circuited Check switch and jack
Relay J2(4123) in
AP-WSM(2) board is broken Change relay J2(4123)
B3(339)in board AP1 is
broken Change B3(339) or board AP1