Page GB-29
Troubleshooting table
Problem
Possible cause
Solution
The LED (12) is illu-
minated although dish-
washer salt has been
added.
The dishwasher salt is
clumpy.
Stir the dishwasher salt using the
end of a spoon or similar.
The water is not running
or it is running only very
slowly.
There is a kink in the inlet
hose.
Arrange the inlet hose properly so
that it is not kinked (please see
„Connecting the inlet hose“ on page
GB-23).
The water tap is not properly
on.
Turn the water tap on completely.
The water is not running
off or only very slowly.
The filters are blocked.
Clean the filters (see „Cleaning the
filters“ on page GB-20).
The outlet hose is kinked, has
been extended or is hanging
too high up/too low.
Lay out the outlet hose in the proper
manner (see page GB-22).
The dishwasher is not
watertight.
The door seal is defective.
Have the door seal replaced (see
„Service“ on page GB-31).
The outlet hose or the inlet
hose is defective.
Have the defective hose replaced
(see „Service“ on page GB-31).
The dishwasher can be
switched on/off, but not
cannot be operated.
The dishwasher can only be
operated when the door is
closed.
Close the door.
The dishwashing results are not satisfactory
Problem
Possible cause
Solution
There are residues or
streaks on the dishes.
The rinse aid is incorrectly
dosed.
Adjust the dispensed dose (see
„Adding rinse aid“ on page GB-11).
There is no dishwasher salt.
Add dishwasher salt (see „Adding
dishwasher salt“ on page GB-12).
The dishwasher salt is
clumpy.
Stir the dishwasher salt using the
end of a spoon or similar.