Page EN-17
Dishwasher operation
Preparation
Requirements:
– You have read chapter „Safety“ on page
EN-6 and understand all the safety notices.
– The appliance is set up and connected as
described in chapter „Installation, connec-
tion and initial commissioning“ on page
EN-23.
– Dishwasher detergent, rinse aid and dish-
washer salt and multitabs are added.
1. Open the tap completely.
2. Open the dishwasher door.
3. Press the button (7) to switch on the
dishwasher.
You will hear a signal tone, all LEDs will
illuminate briefly. The LED (6) will light up
continuously and the display will show
“
– ¦ – –
”.
Selecting the dishwasher
programme
It is recommended that you carry out
a test run before the fi rst dishwasher
cycle in order to remove residues from
the manufacturing process and in order to
ensure that the device functions perfectly.
Carry out this test run when the dishwasher
is empty and without any dishwasher deter-
gent.
1. Select the suitable dishwashing pro-
gramme based on the “dishwasher pro-
gramme table”, see page EN-16.
2. Press the (12) button of the desired pro-
gramme.
The (1) LED of the desired programme
will light up and the display (2) will show
the duration of the selected programme.
(For example, for the Eco programme:
3:10
).
3. If you
– want to delay the start of a programme,
please see “start delay” below.
– want to get particularly dry results,
please use the “extra dry” option (see
below)
– have only loaded the dishwasher half
full or with fewer than 6 place settings,
please use the “Half load” option.
– launch it, continue with „Starting the
dishwashing programme“ on page EN-18.
Delayed start
The washing cycle will normally begin as
soon as the dishwasher door has been
closed.
If you want the cycle to begin later, you can
specify this. The start time can be delayed
between 1 and 24 hours.
• Press the button (10) as many times
as necessary for the display (2) to show
the delay required (
H:00
,
H:01
to
H:24
).
Dishwasher operation
(1)
(7)
(8)
(9)
(10)
(12)
(2)
(4) (5)
(6)