Page EN-36 Installation, connection and initial commissioning
3. Check the alignment with a spirit level.
4. Make sure that the top edge of the ap-
pliance is up to the bottom edge of the
worktop to prevent it from tipping forward
when you open the appliance door.
Screw the dishwasher to the
kitchen units
(48)
(52)
(47)(51)
If you have granite worktops:
1. If you have granite worktops, remove the
internal side cover caps (47), and screw
the appliance to the adjacent kitchen cup-
boards.
2. Replace the cover caps on the counter-
sunk screws (52).
For all other worktops:
• Screw the mounting brackets (48) firmly
to the worktop.
Mounting the front panel
A front panel must only be used for the model
with the article number 97487546.
You can mount a front panel on the appliance
door which matches your kitchen. The weight
of the front panel must be between 4–6 kg.
1. Hold the front panel against the appliance
door such that the lower side of the front
panel is flush with the adjoining kitchen
cupboards.
2. Measure the distance between the front
panel and the control panel.
(49)
3. A gap of 10 mm to 25 mm can be offset
with the 4 mouldings supplied (49). Re-
move the required number of moulding
from the block. To do so, move the mould-
ing vigorously but without using tools.
(49)
(54)
4. If you only need 1 moulding, saw off the 4
protruding feet, clamp the
moulding under the control
panel and secure it using both
countersunk screws (54).
Continue with Step 7.
5. If you need more than 1 moulding, turn
the lower moulding and push it onto the
other mouldings. This hides the feet and
makes the surfaces flat.
