Page EN-29
Installation, connection and initial commissioning
Adjusting the water hardness
Do not allow more than 1 minute to elapse
between the following steps, otherwise the
setting process will be interrupted.
(5)
1. Switch on the dishwasher using the
button (1).
2. Keep the button
P
(5) held pressed in un-
til the water hardness level appears in the
display.
3. Press the button
P
as often as required
until the desired setting is displayed.
4. Around 5 seconds after you push it for the
last time, the dishwasher will automatically
revert to the normal display.
The hardness level setting is saved.
Test run
It is recommended that you carry out a test
run before the first dishwasher cycle in order
to remove residues from the manufacturing
process and in order to ensure that the appli-
ance functions perfectly.
If no water escapes during the test run and if
there are no unusual noises, the appliance is
ready to use.
Carry out this test run when the dishwasher is
empty and without any dishwasher detergent.
See chapter “Dishwasher operation“ from
page EN-21 for the procedure.