Page EN-15
Dishwasher detergents, rinse aids and dishwasher salts
1. Open the cover to the rinse aid compart-
ment (25).
2. Fill the water tank to the “max” mark in
the opening.
3. Wipe away any rinse aid which has spilt
immediately so that you don’t compro-
mise the rinsing results and to avoid in-
creased foaming.
4. Close the cover to the rinse aid compart-
ment again.
Changing the rinse aid dose
We would recommend that you do not change
the dosage that was set by the factory initially.
If the dishes are
– matt and stained after cleaning, increase
the dose.
– sticky and streaky, you should decrease
the dose.
Do not allow more than 1 minute to elapse
between the following steps, otherwise the
setting process will be interrupted.
1. Switch on the dishwasher using the
(18) button.
(5)
(13) (12)
2. Press the P button (13) for 5 seconds
within 60 seconds of switching on.
3. Push the plus button (12) to switch to
setting mode.
The
(5) indicator will flash. The current
value (
d1
to
d5
) will illuminate on the
display (10).
4. Press the P button (13) as often as re-
quired until the desired dose is displayed
(
d1
= low,
d5
= high).
5. Around 5 seconds after you push it for the
last time, the dishwasher will automatical-
ly revert to the normal display.
The selected dose setting is saved.
