Page EN-33
Mounting the front panel
You can mount a front panel on the dishwasher
which matches your kitchen. The front panel
must not exceed a weight of 7 kg.
1. Lay the supplied drilling template on the
reverse side of the front panel in such a
way that the drilling template and the front
panel are flush at the top.
2. Transfer the drill holes from the drill tem-
plate to the front panel.
3. Drill the drill holes in the indicated posi-
tions using a (Ø 2 mm) drill bit.
(g)
(m)
(l)
(i)
(l)
(m)
4. Affix both installation hooks (m) with four
screws (g) each (4×14 mm) onto the front
panel.
5. Affix both mounting pegs (l) using the
screws (i) (3.5×25 mm) onto the front
panel.
6. Hang the front panel on the door of the
dishwasher, hold it in place and open the
door carefully.
(k)
(k)
7. Remove the 4 screws from the inside of
the door. Screw the front panel in place
at these positions using the 4 enclosed
screws (k).
The front panel is then mounted.
Adjusting the accessibility of
the dishwasher door
You can adjust how easy or difficult it is to
open the dishwasher door. This setting is of-
ten required after the front panel has been
mounted. By turning both lower screws you
can change the spring force of the dishwash-
er door.
In order to adjust the dishwasher door
– so that it is easier to access, turn the screws
in an anticlockwise direction.
– so that it is more difficult to access, turn the
screws in a clockwise direction.
Mounting the front panel
