Page EN-30
Installation, connection and initial commissioning
■
Do not cut through the inlet hose.
It contains electrical components.
If the inlet hose is damaged, have it
repaired by a specialist (see „Service“
on page EN-40).
■
Do not use old or previously installed
inlet hoses.
3
¾ inch
Inlet hose
For water supply, you need a water tap with
a ¾ inch screw connector.
1. Screw the safety valve’s lock nut to the
tap hand-tight.
2. Check that the connection to the water
tap is sealed. Turn on the water tap slow-
ly and ensure that no water is escaping.
Then close the valve again.
Installation
NOTICE
Risk of damage!
By selecting incorrect screws, you may
damage adjacent kitchen units.
■
Use the screws which are supplied in
the delivery or screws of an appropri-
ate length.
(c)
1. To protect the worktop against conden-
sation (c), affix the enclosed protective
film to the underside of the worktop.
This will help you minimise damage
to the worktop from the outflow of hot
steam.
(g)
2. Insert the two mounting brackets (g)
into the front slots on the top of the dish-
washer so that you can screw the dish-
washer to the worktop subsequently.
