Hansa C21 O&M Manual - OM-010 Revision L 21/05/2021
© Hansa Chippers 2021
2
Assembling the chipper
When you receive your Hansa brush chipper, the inlet and outlet chute may not be assembled on the chipper. All the fasteners
(bolts, nuts and washers) will be attached to their respective components.
Tools required for assembly (not supplied):
•
16 mm spanner - to fit the inlet and outlet chute
•
17 mm spanner - to fit the inlet and outlet chute
Attach the drawbar
Slide the wire loom through the drawbar so that it
comes out the tow hitch end. Insert three bolts,
spring washers, and heavy washers through the
chassis and the side of the drawbar. Ensure that the
spring washer is touching the bolt head and the
heavy washer is touching the chassis.
Insert two bolts and light washers through the two
center holes in the drawbar bracket, followed by a
heavy washer and nyloc nut. Ensure that the light
washer is touching the bolt head and the heavy
washer is touching the nyloc nut.
Insert two bolts, spring washers, and heavy washers
through the outer holes of the drawbar bracket.
Ensure that the spring washer is touching the bolt
head and the heavy washer is touching the drawbar
bracket. Tighten the nuts and bolts to secure the
drawbar.
Attach the mud guards
Attach the left mud guard - secure the mud guard to
the chipper chassis by inserting three bolts and light
washers through the holes at the base of the
mudguard (indicated by the arrows in the image).
Screw the nyloc nuts on underneath and tighten
them.
Note
: Feed the wire loom through the slot in the
mud guard.
Attach the ‘L’ bracket to the top of the mud guard
by screwing in the bolt, spring washer and heavy
washer which has been circled. Ensure that the
spring washer is touching the bolt head and the
he
avy washer is touching the ‘L’ bracket.
1
Drawbar
bracket
2
