Hans Grohe Talis S2 32440000, Инструкция по сборке и эксплуатации

Страница: 7 / 40

7
Important! The fitting must be installed, flushed and
tested after the valid norms.
Assembly
Flush through the supply pipes.
Mount the S - unions and align them.
Fasten the mixer with the washers.
The hot and cold supplies must be of equal pressures.
Operation
The mixer is activated by lifting the lever handle.
Turning to the left = warmer water,
turning to the right = cooler water.
32440000/32443000: The flow is changed from bath
to shower function by pulling the knob at the upper side
of the spout. After shutting off the water flow, the mixer
returns automatically to the bath function.
Technical Data
Operating pressure: max. 1 MPa
Recommended operating pressure: 0,1 - 0,5 MPa
Test pressure: 1,6 MPa
(1 MPa = 10 bar = 147 PSI)
Hot water temperature: max. 80° C
Recommended hot water temp.: 65° C
Centre distance: 150 ± 16 mm
Connections: cold right -
hot left
Rate of flow by 0,3 MPa: ca. 20 l/min
anti-pollution function
1.
2.
3.
To adjust the hot water limiter on single lever mixers, please
see page 39.
No adjustment is necessary when using a continuous flow
water heater.
Hansgrohe single lever mixers can be used together with
hydraulically and thermically controlled continuous flow
heaters if the flow pressure is at least 0,15 MPa.
Important!
The non return valves must be checked regularly according
to DIN EN 1717 in accordance with national or regional
regulations (at least once a year).
Spare parts (see page 4)
handle 32096000
flange 97406000
nut 97209000
cartridge cpl. 92730000
flange 32440000/32640000 96467000
S-union 32440000/32640000 94140000
aerator cpl. 13914000
selector assy 97978000
diverter knob 97981000
non return valve 94074000
locking screw for handle 95140000
nut 96157000
sleeve 97979000
screw cover 96338000
1�
2�
3�
4�
5�
6�
7�
8�
9�
10�
11�
12�
13�
14�
English
Fault Cause Remedy
Insufficient water - Shower filter seal dirty
- Non return valve hasn't moved back
- Aerator calcified, dirty
- Clean filter seal between shower
and hose
- Exchange non return valves
- Clean aerator, replace as necessary
Mixer stiff - Cartridge defective, calcified - Exchange cartridge
Mixer dripping - Cartridge defective - Exchange cartridge
Hot water temperature too low - Hot water limiter incorrectly set - Set hot water limiter
Instantaneous heater didn’t work - Flow limiter in handshower isn’t
removed
- Filters are dirty
- Non return valve hasn't moved back
- Remove flow limiter
- Clean the filter / exchange filter
- Exchange non return valves