9
Important
! The fitting must be installed, flushed and
tested after the valid norms.
Assembly
Flush through the supply pipes.
Place the mixer including the sealing washer in posi-
tion on the basin / bidet.
Slip the slide washer, washer and collar nut over the
hose and threaded base and tighten the collar nut
by hand.
Tighten screws.
Connect the supply pipes to the isolation valves;
cold right - hot left.
Connect the pull rod to the pop-up waste.
The hot and cold supplies must be of equal pressures.
Operation
The mixer is activated by lifting the lever handle.
Turning to the left = warmer water,
turning to the right = cooler water.
Technical Data
This mixer series-produced with EcoSmart®
(flow limiter).
Rate of flow with EcoSmart:
7 l/min 0,3 MPa
Rate of flow without EcoSmart:
14 l/min 0,3 MPa
Operating pressure:
max. 1 MPa
Recommended operating pressure:
0,1 - 0,5 MPa
Test pressure:
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
max. 80° C
Recommended hot water temp.:
65° C
Hansgrohe single lever mixers can be used together with
hydraulically and thermically controlled continuous flow
heaters if the flow pressure is at least 0,15 MPa.
If the continuous water heater causes any problems or
there is not enough flow of water, the EcoSmart® (6a)
located behind the aerator must be removed.
To adjust the hot water limiter on single lever mixers, please
see page 39.
No adjustment is necessary when using a continuous flow
water heater.
1.
2.
3.
4.
5.
6.
Spare parts
(see page 4)
handle
31094000
flange
96656000
nut
96690000
cartridge cpl.
92730000
seal
95008000
aerator cpl.
13912000
fixing set
96016000
pull rod
96657000
ball joint
92036000
connection hose
96321000
connection hose
97206000
screw cover
96338000
Special accessories
X special tool set
58085000
(order as an extra)
1�
2�
3�
4�
5�
6�
7�
8�
9�
10�
11�
12�
English