6
Assembly see page 60
Maintenance
(see page 66)
• To guarantee the smooth running of the
thermostat, it is necessary from time to
time to turn the thermostat from total hot
to total cold.
• The mixer is equipped with non return
valves. The non return valves must be
checked regularly according to DIN
EN 1717 in accordance with national
or regional regulations (at least once a
year). At this time, please also check the
filter (A) situated on the MTC-thermoele-
ment (98282000). After assembling the
MTC-thermoelement, it is necessary to
check the water temperature at the take
off point as described under the headline
„adjustment“. Before the adjustment,
please check, if the warm water supply is
activated and the maximum temperature
of the warm water is available at the take
off point.
Adjustment
(see page 64)
After the installation, the output temperature
of the thermostat must be checked. A
correction is necessary if the temperature
measured at the output differs from the
temperature set on the thermostat.
Safety Function
(see page 63)
The desired maximum temperature for
example max. 42º C can be pre-set thanks
to the safety function.
Do not use silicone containing acetic acid!
Symbol description
6
Safety Notes
6
Gloves should be worn during installation to prevent
crushing and cutting injuries.
6
Children as well as adults with physical, mental and/
or sensoric impairments must not use this shower
system without proper supervision. Persons under
the influence of alcohol or drugs are prohibited from
using this shower system.
6
The shower system may only be used for bathing,
hygienic and body cleansing purposes.
6
Do not allow the streams of the shower touch sen-
sitive body parts (such as your eyes). An adequate
distance must be kept between the shower and you.
6
The product may not be used as a holding handle. A
separate handle must be installed.
6
The hot and cold supplies must be of equal pres-
sures.
Installation Instructions
• The fitting must be installed, flushed and tested after
the valid norms!
• The mesh washer must be insert to protect the over-
head shower against incoming dirt by pipework. Inco-
ming dirt leads to defects or/and can damage parts
of the shower; such caused faults voids all liability and
guarantee claims.
• Prior to installation, inspect the product for transport
damages.
After it has been installed, no transport or surface
damage will be honoured.
Technical Data
Operating pressure:
max. 1 MPa
Recommended operating pressure:
0,1 – 0,5MPa
Test pressure:
1,6MPa
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
max. 80°C
Recommended hot water temp.:
65°C
anti-pollution function
The product is exclusively designed for drinking water!
English
Содержание AXOR Urquiola 11422000
