Page 4
ASSEMBLY INSTRUCTIONS
1
2
Place the table top upside down on a flat, non-abrasive surface. Attach the table leg to the table top by using the
bolts and washers as shown in the
. Guide the bolts through the holes in the table leg, and into the predrilled
holes in the table top.
Repeat for the other three legs
Fig.1
Hand tighten only.
.
3
After making any necessary adjustments to the alignment of the table legs and the leg connector bracket, use the
hex bolt driver and hex wrench to tighten all nuts and bolts.
each bolt and nut must be tightened a few
revolutions at a time. In order to apply equal pressure to all bolt joints, we recommend working in a cross corner
(X fashion). Repeat until all bolts are tight.
. Over tightening may strip bolts. Cover all nuts
and bolts with covers.
Note:
Do not over tighten
FOOT CAP
E
F
H
D
F
G
A
C
B
Attach a leg to the leg connector bracket by carefully guiding the bolts already in place on the table legs (each leg
has two bolts) through the holes in the leg connector bracket. Add a washer and a nut to the end of each bolt as
shown in the
.
Repeat on the other three legs.
Fig.2 Hand tighten only.
Fig.1
Fig.2
