Page 4
ASSEMBLY
INSTRUCTIONS
1
2
3
Assemble furniture on a smooth, non-abrasive surface.
by using two
1/4"x18 mm bolts and washers as shown in
Fig.1
. Guide the bolts through holes in back frame, into
pre-drilled holes in the
.
Hand tighten only.
and back frame
by using four
mm bolts and washers as shown in
Fig.2
.
Hand tighten only.
A
and seat frame by using four
mm bolts and four washers as shown in
Fig.3
.
Hand tighten
only.
Attach the back frame to right arm
right arm
Attach the seat frame to right arm
ttach the left arm
to back
1/4"x18
1/4"x18
B
Fig.1
A
Fig.2
C
Fig.3
Attach the complete base to the complete seat by using four 5/16"x40 mm bolts and washers as shown
in
Fig.4
. Guide the bolts through holes in base, into the pre-drilled holes in the seat.
Hand tighten only.
Using the hex bolt driver
provided, tighten all bolts.
Do not over tighten bolts. If nuts and bolts are
too tight or too loose, the glider will not function properly.
Test the operation of glider. Gliding
motion
should be smooth. Adjust tension on the glider
brackets, nuts and bolts as needed. Cover nuts
and bolts with covers provided.
H
F
G
Fig.4
E
D
K
I
J
K
I
J
K
I
J
K
I
J
