3.
Remove the cardboard cover from the ignition well as shown in Figure 5.
Remove any lava rock or fire ice on top of ignition well.
Cardboard Cover
4. Lift off the tank door, place the tank in the holder and use the chain to hold
the tank. Connect the regulator as shown in Figure 6. Turn the black handle
clock-wise to tighten. Turn the handle counterclock-wise to remove. The
hose must point down. Open the control door and check that the valve is
turned all the way clockwise to the “OFF” position. Open the tank valve.
Apply a solution of soapy water to the tank-regulator connection and to the
valve-hose connection to check for leaks. If soap bubbles continue to form,
the connection has a leak. If a leak is found, close the tank valve and
tighten all connections.
NEVER USE A FLAME TO CHECK FOR
LEAKS.
Figure 6
5. Tighten threaded knobs found on tank tray (Figure 7) so that the LP tank
cannot move from side to side. Do not remove plastic cap from end of
threaded section.
Figure 7
Figure 5
