7
• Select the appropriate measurement range (EC or TDS).
• Wait a couple of minutes for the temperature sensor to reach
thermal equilibrium. The display will then show the measurement
automatically temperature compensated for temperature with the
appropriate indication among the following:
“
µ
S
”
symbol indicates the meter is in
EC mode;
“
mg/L
” symbol indicates the meter is
in TDS mode.
TAKING TEMPERATURE MEASUREMENTS
• Submerge the tip (4 cm/ 1½”) of the
probe into the sample to be tested.
• Select the °C mode.
• Stir briefly and wait a couple of minutes
for the reading to adjust and stabilize.
The display shows the temperature value.
Notes:
• If the display shows only a “
E
”
on the right side of the LCD, the
reading is out of range.
• It is recommended to clean
often the probe with
HI700661
Cleaning Solution.
• After measurements have been
completed, the instrument should
be switched off, and the probe
cleaned and covered with the
protective cap.
