Remote Controller
User's Manual
HCT-2216/HCR-2216
5. INSTALLATION AND SETUP
This equipment operates normally after wireless communications between the
This equipment operates normally after wireless communications between the
transmitter and the receiver which is the same Frequency Channel and Address
Code.
5-1. Setup for the Radio Frequency (RF) Channel
The Radio Frequency (RF) channel must adjust the same frequency between
Open the case of the transmitter and the receiver; see the Channel Switch is
the transmitter and the receiver.
p
adjusted the same channel number according to the table as below.
설정 주파수(㎒)
CHANNEL NO
*기기명:HCT-2216
10
1
0
173.6250
0
0
0
3
4
5
0
0
0
173.6375
173.6500
173.6625
1
2
173.6750
173.6875
0
9
A
B
0
0
0
0
8
6
0
7
173.7000
173.7125
173.7250
173.7375
173.7500
173 7625
0
0
0
B
C
D
173.7625
14 CH
TOTAL
173.7750
173.7875
NOTICE
DO NOT CHANGE the RF Channel and the Address Code Switch at Site
because of an Accident.
If Necessary to Change Any Switch, Contact Us (Engineering Departmaent)before Change.
If Any Abnormality or Problemis Found While Using the Transmitter and the Receiver,
Stop its Use and Call to your Local Dealer or Our Factory
Stop its Use, and Call to your Local Dealer or Our Factory.
Hangil Control Co., Ltd
7
2008-09-24
