Hangar 9 Taylorcraft 26cc Hangar 9, Инструкция по сборке

Страница: 20 / 36

20 Hangar 9 Taylorcraft 26cc BNF

3. Apply 2–3 drops of thin CA in each of the holes to
harden the threads in the surrounding wood. This will
make the screws more secure and help prevent them from
vibrating loose.

4. Secure the painted plywood plate in the fuselage using
four 2mm x 10mm washer head wood screws and a #1
Phillips screwdriver. Note that the plate will have the single
magnet to the front of the fuselage as shown.

5. Install the seat by attaching the magnet from the seat
to those in the painted plywood plate.

6. The pilot comes with a helmet and life jacket that can
be removed. Remove these items to make your pilot look like
a civilian pilot for your model.

7. Place the pilot in the cockpit of your model. His legs
will straddle the fuel tank when installed. Use hook and loop
tape or silicone adhesive to secure the pilot in the seat.
Wing Strut Installation
Required Parts
Wing panel (right and left)
Wing strut assembly (right and left)
4-40 x 1/2-inch button head cap screw (4)
4-40 lock nut (4)
Required Tools and Adhesives
Nut driver: 1/4-inch Hex wrench: 5/64-inch

1. Locate the items to attach the wing struts to the
wing panels. You will also need the right and left wing panels
for this section of the manual.

2. When installing the wing struts, the airfoil of the
strut will match that of the wing when the jury struts are
facing toward the fittings on the wing. Use two 4-40 x 1/2-
inch button head cap screws and two 4-40 lock nuts to
secure the struts to the fittings. Use a 5/64-inch hex wrench
and 1/4-inch nut driver to tighten the hardware.