10
Step 8
Secure the servo using the screws provided with the
servo. Remove the stock servo horn and install a long
servo arm in its place. Remove the side of the arm that
does not align with the control horn.
Step 9
Enlarge the outer hole of the servo arm using a
5/64-inch (2mm) drill bit. Remove the pushrod keeper
from the linkage and slide the bend through the servo
arm. Secure the pushrod to the servo arm by replacing
the pushrod keeper.
Step 10
Attach the clevis to the control horn. With the radio system
on and the aileron trim and stick centered, check that the
aileron is centered when viewed from the wing tip. Adjust
the length of the linkage if necessary.
Step 11
Use tape on the servo lead to prevent it from falling back
into the wing.
Step 12
Repeat Steps 1 through 11 for the remaining aileron servo.
Section 1: Aileron Servo Installation
