20
Required Parts
• Wing panels
• Fuselage
• Wing tube
• Stabilizer tube
• Tap handle
• 4-40 tap
• Drill
• Drill bit: #43
• 1/4-20 x 2" nylon bolt (2)
• 4-40 x 1/2" socket head screw (2)
Required Tools and Adhesives
• Flat screwdriver w/short handle
Step 1
Remove the four 4-40 x1/2” screws securing the hatch
to the fuselage. Remove the hatch and store it in a safe
place until later.
Step 2
Locate the wing tube and carefully slide it into one
wing panel. Slide the wing (with tube) into the wing
tube opening in the fuselage. Make sure the wing panel
alignment pins slide into the holes provided in the
fuselage. Be sure the alignment pins are secure in the
wing halves before installing the wings. If they are not,
remove the pin and apply a small amount of thin CA into
the tube socket and reinstall the alignment pin.
Step 3
Carefully slide the remaining wing panel onto the wing
tube that projects from the fuselage. The fit may be tight;
use caution when inserting the wing panels onto the wing
tube and fuselage.
Step 4
Secure the wing panels using the 1/4-20 x 2" nylon wing
bolts.
Step 5
Insert the stabilizer tube into one of the stabilizer
halves. Remove the covering to expose the hole for the
stabilizer tube bolt.
Section 8 – Wing and Stabilizer Installation
