11
Step 5
Thread the two wing nuts onto the threaded rods to secure
the fin to the stabilizer. Don't over-tighten the wing nut and
damage the underlying wood.
Step 6
Slide the fin into position. Make sure the control rod
for the rudder is on the top side of the stabilizer when
installing the tail assembly.
o
Step 7
Locate a #4 washer and 3mm x 10mm machine screw.
Slide the washer onto the screw, then apply a small
amount of threadlock on the screw.
o
Step 8
Insert the screw into the hole in the fuselage and
through the stabilizer to the pre-installed blind nut on
the top of the stabilizer. Use a #2 Phillips screwdriver
to tighten the screw.
Section 2: Fin and Stabilizer Installation
