Hangar 9 frenzy 100, Инструкция по сборке

Страница: 8 / 32

8
Required Parts
• Fuselage • Wing
• Stabilizer • Fin
• 1/4-20 x 2-inch nylon bolt
Required Tools and Adhesives
• 30-minute epoxy • Epoxy brush
• Mixing stick • Mixing cup
• Ruler • Felt-tipped pen
• Square • Flat screwdriver
• Hobby knife • Paper towels
• Rubbing alcohol

Step 1
Attach the wing to the fuselage using the 1/4-20 x 2-inch
nylon bolt.

Step 2
Slide the stabilizer into the slot in the fuselage. Measure
each side to center the stabilizer in the slot.

Step 3
Measure from each wing tip to the tips of the stabilizer.
The stabilizer is aligned when both measurements are
equal as shown.
A
A=A
A

Step 4
Check that the stabilizer is parallel to the wing. If not,
lightly sand the slot in the fuselage until the stabilizer
rests parallel to the wing.
Parallel
Stabilizer and Fin Installation