15
Note
:.It.may.be.necessary.to.slightly.
trim.one.of.the.servo.mounting.
blocks.to.clear.the.servo.wire.
Step 12
Remove.the.servo.and.use.a.1/16".(1.5mm).drill.bit.to.
predrill.the.holes.for.the.servo.mounting.screws.marked.
in.the.previous.step..Use.the.screws.supplied.with.
the.servo.to.mount.it.to.the.servo.mounting.blocks.
Step 13
Connect.an.18".(458mm).Servo.Lead.extension.
(JRPA099).to.the.servo.lead..Secure.the.connectors.by.
tying.them.in.a.knot.using.dental.floss.(as.shown).or.
by.using.a.commercially.available.connector.clamp.to.
prevent.the.servo.leads.from.becoming.disconnected.
Note
:.It.is.always.a.good.idea.to.secure.the.
servo.connector.and.servo.extension.together.
to.prevent.the.wires.from.becoming.unplugged.
Step 14
Tie.the.preinstalled.string.onto.the.servo.extension..
Tie.a.small.weight.onto.the.string.at.the.root.
of.the.outer.panel..Use.the.string.and.weight.
to.pull.the.extension.out.of.the.tip.panel.
Step 15
Place.the.hatch.cover.in.position.in.the.aileron.
opening..Measure.in.1/8".(3mm).on.all.four.
sides.of.the.hatch..Drill.four.1/16".(1.5mm).holes.
at.the.intersections.of.the.lines.as.shown.
Note
:.Drill.through.the.servo.hatch.and.the.
underlying.hatch.mounts..Use.caution.not.to.
accidentally.drill.through.the.top.of.the.wing.
Section 2: Aileron Installation