40
Section 14: Linkage Installation
Step 9
Cut the wire 3/8" above the bend.
Step 10
Slide the wire through the outer hole in the elevator
servo arm. Secure the wire using a nylon wire keeper.
It may be necessary to drill out the hole in the servo
arm using a 5/64" drill bit.
Note
: Use a 1/4" piece of fuel tubing on the
clevis to keep it from opening during flight.
Step 11
Thread a clevis onto a 7" wire a minimum of
10 turns.
Step 12
Center the rudder servo electronically using the radio
system. Install a servo arm onto the rudder servo.
Attach the pushrod with clevis to the steering control
horn. Physically place the steering control horn
parallel to the rudder servo arm. Mark the pushrod
where it crosses the holes in the servo arm.
Step 13
Bend the wire 90 degrees at the mark made in the
previous step. Cut the wire 3/8" above the bend.
