14
Section 4: Installing the Aileron Control Horns and Linkages
Step 6
Locate the aileron control wire (6" threaded on one end)
and thread on a clevis a minimum of 12 turns. Attach
the clevis to the middle hole in the control horn. To
hold the aileron at the neutral position, place a piece
of masking tape on the aileron to secure it to the wing
trailing edge. With the aileron at neutral and aileron servo
electronically centered, mark the wire where it crosses
the aileron servo arm.
Step 7
Remove the clevis and wire from the control horn and
make a 90-degree bend at the mark made in the previous
step. Cut off the excess wire leaving 5/16" remaining after
the 90-degree bend.
Step 8
Re-attach the clevis, securing it to the horn using a clevis
keeper. Slide the other end of the wire through the aileron
servo arms outermost hole and secure it with a wire
keeper as shown.
Step 9
Repeat Steps 1 through 8 for the opposite aileron control
horn and linkage.
