12 Mini Maxx Installation Manual • www.hsperformance.com
INSTALLATION CONTINUED
PrE-TUrBO MOUnT
1. Drill a
5
/
16
” hole into the exhaust manifold where all the exhaust runners of the manifold come togeth-
er, just before the turbo exhaust inlet. Then tap the hole with a
1
/
8
” NPT tap and mount the Pyrometer
Probe in the hole. Use a
9
/
16
” wrench to tighten the probe holder or tube fitting to the down tube. Then
tighten the Pyro Probe Cap to the holder using a
9
/
16
” wrench.
2. Run the Pyro Cable up to engine bay; let the end of the cable sit while installing the PCH Board.
For pictures and vehicle specific information, see the Vehicle Specific Features/Info Section starting on Page 30
Warning:
If any debris such as drill bits and metal shavings drop inside the manifold, we advise
that the manifold be removed from the vehicle so that the debris can be removed before starting the
vehicle again.
TOOl TiP, PrE-TUrBO MOUnT
When drilling into the exhaust manifold, metal spews, shavings, and broken drill bits can fall inside. This
can be hazardous to your turbo when the engine starts. Try doing four things to avoid this possible prob-
lem. One, use a high quality twist bit and a slow speed drill, about 500-800 rpm. Two, start with a small
pilot bit about
1
/
8
”, then use the full
5
/
16
” bit after the smaller one has punched through. Three, grease your
drill bit in addition to the normal lubricant, this will catch flying spews as they are cut. Four, just prior to
punching through into the inside of the manifold, start the engine and build up exhaust pressure on the
inside of the manifold (blows spews outside the manifold instead of letting them fall inside).
POST-TUrBO MOUnT
1. Find a location on the exhaust pipe that is 3-6” downstream from the turbo charger output. Then drill a
5
/
16
” hole and run a
1
/
8
” NPT tap into the hole. Mount the Pyrometer Probe in the threaded hole using a
9
/
16
” wrench to tighten the probe holder or tube fitting to the down tube. Then tighten the Pyro Probe
Cap to the holder using a
9
/
16
” wrench.
2. Run the Pyro Cable along the brim of the engine bay, and then let the end sit when installing the PCH
Board.
For pictures and vehicle specific information, see the Vehicle Specific Features/Info Section starting on Page 30
Securing Pyro
Pyro line secured
Содержание Mini Maxx
Страница 52: ...52 Mini Maxx Installation Manual www hsperformance com...
Страница 62: ......