H&S LW1100, Руководство оператора

Страница: 20 / 40

-18-
BALE RISERS - ROUND BALES
There are two risers at the front of the machine. All round bales must be wrapped with the riser in the
down position. These risers serve as a loading platform for round bales in the down position.
BALE RISERS - SQUARE BALES
Placing the risers in the up position, allows a square bale to be wrapped sideways. Be sure to remove
the spikes from the low position and pin them into the end of the risers after raising them. The automatic
start bar must be moved to the up position for square bales as shown below. Lift start bar and slide to
your right and rest on the higher section of the bracket. Remove hair pin from end hole and place in
second hole from the end of the rod. This will secure start bar in the up position. Start bar is now in
position to be activated by square bale when placed on the riser in the up position. Bales can also be
wrapped lengthwise with the installation of the optional Riser Shelf. When risers are lowered for round
bales, start bar must again be lowered.
OPERATION
Always shut engine
off before making
adjustments.