H&S HD, Руководство оператора / Каталог запасных частей

Страница: 45 / 54

TO PREVENT SERIOUS INJURY OR DEATH
NEVER OPERATE THIS UNIT UNLESS EMERGENCY STOP
FUNCTIONS PROPERLY
UNLOADING
1. Park forage box on level ground whenever possible during unloading. Lock tractor parking brake.
2. Connect PTO to tractor, locking securely in place. USE 540 PTO ONLY.
3. Engage PTO.
4. To engage cross conveyor INTERMITTENTLY, rotate clutch lever (A) clockwise and hold with hand
pressure. If hand pressure is removed, the cross conveyor will stop.
5. To engage the cross conveyor CONTINUOUSLY, rotate clutch lever (A) clockwise until it locks in the
engaged position. Cross conveyor speed is controlled by tractor RPM only.
6. Quickly engaging/disengaging beaters (lever B) will allow beaters to clear material a little at a time to
avoid exceeding blower capacity.
7. When beaters are clear of material, move control lever (B) to apron speed positions. Variable speed
drive offers you a number of unloading speeds to choose from. With experience and depending on the
type of forage, you will be able to select a speed which will match your blower capacity.
Unloading speed may also be varied by increasing or decreasing engine speed of tractor.
W A R N I N G
-10-
1. Pushing the emergency stop bar rearward or
pulling the trip cables will activate the stop to
disengage position.
2. Activating emergency stop only stops box
functions. The PTO shaft will continue to rotate.
3. Keep excessive slack out of trip cables.
4. Trip emergency stop occasionally, and when
starting the unit after periods of storage to insure
proper function.
5. To reset, move lever (A) clockwise to engage
position.
A B
ITEM PART NO. DESCRIPTION
1. G90 Dust Cap
2. 3G19 Snap Ring
3. 3G18 Race #15245
4. 3G7 Bearing #15101
5. X9 Spacer
6. G83 Set Screw
7. G76 Worm
8. G114 Gearbox Housing
9. X8 Gearbox Bushing
10. S138 3/8 x 2-3/8’’ Square Key w/Round Ends
11. S139 Worm Gear Side Shaft
12. S437 3/8 x 1-3/8’’ Square Key w/Round Ends
13. G65 Plug 3/8’’
14. 5B10 1/4 x 1’’ Woodruff Key
15. S140 Worm Gear Front Shaft
16. L3G24 Gearbox Bearing #15113
17. G115 Seal
18. G84 Cap Screw
19. X75 Cover Bushing
20. G116 Worm Gearbox Cover
21. G77 Worm Gear
22. G91 Vent Plug
23. G117 Cap
24. G120 Seal 1-7/8’’
* G118 Worm Gearbox Complete
NOTE: * (Means Not Shown)
- 43 -
FIGURE 7
WORM GEARBOX