GB
71
Cut a hole approximately 180 mm in
diameter.
Then cement in a wall connector with
fire proof mortar (not supplied).
Let the mortar dry before the stove is
connected to the chimney.
Tap out the knock out in the
rear panel using a hammer and
cut the heat deflector on the
rear side of the back panel
LEK
LEK
LE
Mount the back plate and install
the connection pipe on the
connection.
Make sure that the gasket does
not work loose from its position.
Installation of the surrounds
for the respective models is
described later on in these
installation instructions.
Seal between the connection
pipe and the connector in the
wall using fire rope. If further
sealing material is required, heat-
resistant sealant may be used.
Connection to the chimney
Rear connection to a masonry chimney
Mark out the centre for making a hole in the wall to the
flue. Check that the connection height in the chimney breast
corresponds to the height of the connection pipe from the stove.
