Handife Q1P-CX49-380, Инструкция по эксплуатации

Страница: 10 / 58

(a) Adjust the screw downward (-) to reduce the amount of paint and reduce the thickness of
the paint
(b) Adjust the screw upward (+) to increase the amount of paint and increase the thickness of
the paint
Adjust the needle adjusting screw to meet your require-
ment.
EN-7
Turn on the power switch and press the trigger to spray paint.
Start working
NOTE: For easier and faster cleaning, consider purchasing the Rapid Clean Kit
Cleaning and maintenance
NOTE: Proper clean up is essential to keep your sprayer in optimum working condition. Dried
by-products act like glue and will cause moving parts to stick. Failure to properly clean your paint
sprayer will damage the unit. Taking the time to clean your sprayer immediately after use will help
your sprayer last longer and work correctly. If you are finished with the project or are not going to
use the sprayer within the day, you must follow these instructions for proper clean up. Never
store the sprayer longer than 30 minutes without cleaning.
1. Unplug sprayer from electrical outlet and pull trigger on spray gun so material inside unit flows
back into the container.
2. Empty any remaining (stain or paint) material from the container.
3. Fill container approximately 1/2 full with appropriate cleaning solution. For latex, use
warm soapy water; for oil-based, use a cleaning solution recommended by the material
manufacturer.
4. Plug sprayer into an electrical outlet.
5. Press the switch of the sprayer until the cleaning solution passes through the spray nozzle for
several seconds. (See Figure A.)
6. Remove container and properly discard the cleaning solution.
7. Unplug the sprayer from the electrical outlet.
STEP ONE: CLEAN UP INSTRUCTIONS