User Manual RCx-B-xxxAx-8.09
Page 3 of 18
www.hanbayinc.com | 1 800 315 4461
Rev.2021.8 [email protected]
The voltage transformer holder (white plastic part, see image below) will have to be unscrewed to access
the terminal block on the circuit board for wiring. It is easiest to remove the central screw and loosen the
other, then rotate the holder out of the way. When wiring is complete screw holder back into place.
Do not remove or change the existing
BLACK
and
WHITE
wires that connect the battery board
to the processor board.
Once the cable and cable gland are installed, connect the wires to the pins on the terminal block as
indicated here:
Pin Function
6
Already Connected to battery board, then
transformer board serially
Connect live wire to loose red cable with crimp
connector (see below)
5
Already Connected to battery board, then
transformer board serially
Connect neutral wire to loose black cable with
crimp connector (see below)
4
Feedback signal (4-20 mA)*
3
Not connected
2
Isolated
**
input signal gnd.
1
Isolated
**
input signal (4-20 mA)
* “feedback” available in RCx-B-xxxA
F
version only.
** “isolated” available in RCx-B-xxxA
I
and xxxA
F
versions only.
Internal wires for 24 VDC
White +24 VDC
Black 0 VDC
Battery connector and
wires.
Red: positive
Black: negative
AC input
Red
– Live
single phase
Black - Neutral