17
The symbol on the product indicates that this product
should not be treated as domestic waste, but must be
correctly disposed of in order to prevent possible negative
consequences for the environmet and the human health.
Regarding the recycling of this product, please contact the
sales agent or dealer of your product, your after-sales service
sor the appropriate waste disposal service.
II.
INSTALLATION INSTRUCTION
1.
INSTALLATION PLACE
● The applia e ust o ly e i stalled i ade uately
ventilated premises. Device is locatedon the ground if
necessary, must have a hood and exhaust fans.
2.
POSITIONING
● U pa k the applia e a d a efull e o e the p ote ti e
film from the external panels. Use a suitable solvent to
remove any glue residue left on the panels.
●
Remove the protective film and make sure the packing
material is not dispersed in the environment but disposed of
according to the current regulations in the country where the
product is used.
●
Left and right side of the machine during installation so that
the space should be givento the nearest 10 cm.
●Positio the
device on a flat surface and if necessary, adjust
the height according to the characteristics of the environment
by means of the feetis required.
●
Dispose of the packaging as instructed in the chapter on
“afegua di g the e vi o
e t .
●At the egi i g
of this manualfor the device in general
dimensions and connections, see installation diagrams.
3.
ELECTRICAL CONNECTION
●The devi e
must be connected to the power supply in
accordance with necessary regulations.
●Befo e o e ti g the applia e to the ai s po e suppl ,
make sure the voltage and frequency shown on the appliance
rating plate correspond with that of the power supply.
● The applia e ust e pe a e tl o e ted to the ai s
power supply using an H05 RN-F type cable.
●Ca e
must be installed in front of the device during the
device can be locked in open position (lockplug, key lock, or
similar instruments).
●
The appliance must be suitably earthed. Otherwise, the
Authorized Service will not be by the mounting of the product.
●I additio ,
the device must be connected to a system of
copotentiality.
●The
outlet is connected to the line only for the load of the
device must have a fuse of 16 A.
3.1
INSTALLING THE POWER SUPPLY CABLE
To connect the power supply cable, proceed as follows:
●The po e o dis i the a k ight of the de i e
output.
●“uita le fo
connecting the outlet.
●The
leakage current of30 mAis connected to the relay, even
with the main board should have an insurance system.
The manufacturer declines any responsibility for failure to
comply with existing accident prevention standards.
4.
WATER MAINS CONNECTIONS
(Refer to the installation diagrams at the beginning of this
handbook).
Fit a mechanical fitler and shut-off cock between water inlet
pipe and the mains water supply. Before connecting the
fitler, run off a certain amount of water to remove any
ferrous particles from the piping.
● The ate i let ust e o
nected to a drinking water
supply with pressure of 4bar
4.2 WATER DRAINAGE SYSTEM
Earn drain plug located on the left goes to the machine with
the help of water in waste water flows through the line. This is
the place where the line goes to work correctly, the machine
must be above the level.
Folding and pinching all along the line of drain hose and the
metal brackets on the check and drain pipe line system to
p e e t the a u ulatio of ate at least 5 ° Make su e the
slope.
Important:
Ventilation at the bottom of
the device status is appropriate, and
please make sure that waste water
evacuation systemis working actively.
