38
Assembly of spray head and
high-pressure hose
Fit the outer part 1 to the handle 2.
Screw in the direction of the arrow A and
tighten.
Fit the high-pressure hose to the handle
as illustrated.
OPERATION
General information before starting
The appliance is fitted with an automatic stop system (A.S.S.) that stops the appliance in standby. It is
therefore important to start with the power switch first and then to open the nozzle. The automatic stop
system will then start the appliance and stop automatically when the spray handle is released. Always
lock the spray handle with the safety catch when not spraying.
Observe the following:
If the appliance starts automatically without the spray handle being pressed, this will cause air
bubbles in the water. This is not harmful.
Never leave the appliance in standby for more than 5 minutes. For the safety of the appliance, the
power switch must be turned off.
Check that all high-pressure connections and high-pressure hoses are correctly connected and that
there are no water leaks. If the appliance is fitted with a pressure regulator:
When the pressure is set to minimum, A.S.S. will not be activated. For this reason, never leave the
appliance in bypass for more than 1 minute.
Do not activate the spray handle too frequently. (This will cause malfunction.)
Preparation
1.
Check that the power switch is turned off
and that the water filter is installed in the
inlet.
2.
Connect the quick-release coupling without
using any tools.
3.
Connect the water hose, which must have
an internal diameter of at least 13 mm, to
the outlet 1 in the figure.
