Hamron 220-137, Инструкция пользователя

Страница: 46 / 53

EN
46
1� Put the switch in the ”OFF” position (Figure 1)�
2� Check that the input voltage and frequency (volt/Hz) correspond with the specification on the
rating label� If the power supply is correct, the high-pressure washer can be connected�
3� Position the high-pressure washer as close as possible to the water supply�
4� When in use, the high-pressure washer must stand on a secure and stable surface, as shown
in Figure 2�
5� Fit the water-jet pipe on the spray gun and rotate until the two parts are fully attached
(Figure 3)�
6� Connect the spray gun to the high pressure hose (Figure 4)�
7� Connect the high pressure hose to the water outlet� (Figure 5)�
8� Connect the water supply hose to the female coupling (Figure 6), and then connect to the
high-pressure washer’s water inlet� The hose must have an internal diameter of at least
13 mm (1/2 inch) and must be reinforced� The water supply must as a minimum correspond
with the high-pressure washer’s capacity�
2 1
3 4
6 5