5.
Figure 7
Installing Fan to
the Electrical Box
WHEN MOUNTING THE FAN ON A SLOPED
CEILING, THE STANDARD BALL/DOWNROD
MOUNTING METHOD MUST BE USED. THE
MOUNTING PLATE MUST BE MOUNTED SO
THAT THE SLOT OPENINGS ARE ON THE
LOWER SIDE BY SLIDING THE MOUNTING
PLATE FROM THE TOP DOWN.
Pass the 120-volt supply wires through the
1.
center hole in the ceiling mounting plate as
shown in Figure 7.
Install the ceiling mounting plate on the
2.
electrical box, by sliding the mounting
plate over the two screws provided with the
electrical box (Figure 7). If necessary, use
leveling washers (not included) between the
mounting plate and the electrical box. Note
that the flat side of the mounting plate is to
-
ward the electrical box (Figure 7).
Securely tighten the two mounting screws.
3.
Carefully lift the fan assembly up to the
4.
ceiling mounting plate. Make sure the tab
on the mounting plate is properly seated in
the groove in the hanger ball.
Making the Electrical
Connections
REMEMBER
to disconnect the power. If
you feel you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
Follow the steps below to connect the fan
to your household wiring. Use the wire
connecting nuts supplied with your fan
and supplied with remote control. Se-
cure the connectors with electrical tape.
Make sure there are no loose strands or
connections (Figure 8).
Connect the ground conductor of the 120v
1.
supply (this may be a bare wire or a wire
with green colored insulation) to the green
ground lead(s) of the fan (Figure 8).
Connect the fan motor white wire to
2.
the receiver white wire using a wire nut
(Figure 8).
Connect the fan motor black wire to
3.
the receiver black wire using a wire nut
(Figure 8).
Connect the fan motor blue wire to the re-
4.
ceiver blue wire using a wire nut (Figure 8).
Connect the receiver black wire to the
5.
supply black (hot) wire using a wire nut
(Figure 8).
Содержание Trieste
Страница 1: ......
