Page 19
AVERTISSEMENT:
1. Avant de commencer à installer ce luminaire ou d'enlever l'ancien luminaire,
déconnectez le courant en éteignant le disjoncteur ou en enlevant le fusible
correspondant du coffret à fusibles.
2. CONSULTER UN ELECTRICIEN QUALIFIE POUR TOUTE
QUESTION RELATIVE A L'ELECTRICITE.
3. En cas de questions non relatives à l'électricité à propos de ce luminaire,
veuillez contacter notre centre de Service à la Clientèle au 1-877-527-0313
ou visiter www.homedepot.com. Veuillez indiquer votre UGS 704-064 ou
UPC 725916822934.
4. Conserver votre reçu et ces Instructions comme Preuve d'Achat.
OUTILS REQUIS POUR L'ASSEMBLAGE & L'INSTALLATION
(non inclus):
2 Ampoules Lunettes de Protection Echelle Gants Dénudeur de
(60 watts maxima) Câbles Electriques
(ou équivalent LFC)
Tournevis à tête Plate Tournevis à Croisillon Ruban Adhésif Isolant Pince Pour Câbles Electriques
Page 6
PARTS INCLUDED FOR INSTALLATION (parts are not to scale):
3ea Wire Connectors (#11)
2ea Outlet Box Screws (#12) 1ea Mounting Strap (#13)
1ea Ground Screw (#14) 2ea Mounting Screws (#15)
INSTALLATION INSTRUCTIONS:
1. Screw the two Mounting Screws (#15) into the Mounting Strap (#13). Mount the
Mounting Strap (#13) to the Outlet Box (#10) using the two Outlet Box Screws
(#12). [Make sure the heads of the Mounting Screws (#15) are facing outside when
the Mounting Strap (#13) is attached to the Outlet Box (#10).]
2. Wrap the ground wire from the fixture around the Ground Screw (#14) on the
Mounting Strap (#13), and then connect the ground wire from the fixture to the
ground wire from the Outlet Box (#10). Connect the white wire from the fixture to
the white wire (neutral wire) from the Outlet Box (#10). Connect the black wire
from the fixture to the black wire (live wire) from the Outlet Box (#10). Cover the
three
connections using the
three
Wire Connectors (#11). Wrap the
three
wire
connections with electrical tape for a more secure connection. Position the wires
back inside the Outlet Box (#10).
Note: If you have electrical questions, consult
your local electrical code for approved grounding methods.
3. Place the Canopy (#1) over the Outlet Box (#10). Allow the heads of the Mounting
Screws (#15) to come out through the large ends of the keyholes on the Canopy
(#1). Twist the Canopy (#1) clockwise until the heads of the Mounting Screws (#15)
slide into the narrow ends of the keyholes. Tighten the Mounting Screws (#15) to
secure the Canopy (#1).
4. Before completing Installation, please return to the Assembly Instruction #4.
5. Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn
the light switch on to activate the fixture.
