1
Preparing the canopy
2
Preparing the motor
□
Remove the cotter pin (FF) and clevis pin (EE), and
loosen the two collar setscrews (GG) from the fan
motor assembly (F) collar.
3
Assembling the fan
FF
F
EE
GG
GG
Assembly
8
WARNING:
Failure to properly install the cotter pin (FF)
could result in the fan loosening and possibly falling.
NOTE:
If a longer downrod is needed (not included), take
out the screw located in the hanger ball, lower the hanger
ball and remove the pin. Remove all three pieces from the
downrod, and assemble them onto the new longer downrod
before proceeding to the downrod installation.
□
Route the wires exiting from the top of the fan motor
assembly (F) through the coupling cover (E). Ensure
the slot openings are on top.
□
Route the wires through the canopy bottom cover (C),
canopy (B) and then through the hanger ball/downrod
assembly (D).
□
Align the holes at the bottom of the hanger
ball/downrod assembly (D) with the holes in the collar
on top of the fan motor assembly (F).
□
Carefully insert the clevis pin (EE) through the holes
in the collar and the hanger ball/downrod assembly
(D). Be careful not to jam the clevis pin (EE) against
the wiring inside the hanger ball/downrod assembly
(D).
□
Insert the cotter pin (FF) through the hole near the
end of the clevis pin (EE) until it snaps into the locked
position.
□
Firmly tighten the two collar setscrews (GG) on top of
the fan motor assembly (F).
□
Remove the canopy bottom cover (C) from the canopy
(B) by turning the canopy bottom cover (C) counter-
clockwise.
□
Remove the mounting bracket (A) from the canopy (B)
by removing the non-slotted canopy mounting screw
(BB) from the bottom of the canopy (B) and loosening
the slotted canopy mounting screw (BB) a half turn
from the screw head. Next, turn the canopy (B)
counterclockwise to remove the mounting bracket (A)
from the canopy (B).
BB
A
B
C
BB
D
B
E
C
F
FF
EE
GG
GG
