Finishing the
Installation
STANDARD CEILING INSTALLATION
Slide canopy up to the ceiling as shown in
Figure 13 leaving a 1/8" clearance
between the canopy and the ceiling.
Make sure you place the wires safely into
outlet box. Secure the canopy to the
hanger bracket with the four screws with
your fan. Slide the canopy ring over the
canopy and tighten by turning the ring
counter-clockwise.
WARNING
MAKE SURE TAB AT BOTTOM OF HANGER
BRACKET IS HANGER PROPERLY SEATED IN
GROOVE OF HANGER BALL BEFORE
ATTACHING CANOPY TO BRACKET. FAILURE
TO PROPERLY SEAT TAB IN GROOVE COULD
CAUSE DAMAGE TO ELECTRICAL WIRING
CLOSE-TO-CEILING INSTALLATION
Remove the fan from the tab on the
hanger bracket. Secure the canopy to
the hanger bracket as shown in Figure
14 with four screws included with your
fan. Slide the canopy ring over the
canopy and tighten by turning the ring
counter-clockwise.
Figure 13
Figure 14
Allow 1/8"
Clearance
Allow 1/8"
Clearance
8.
