8
Fan without Light Kit
(Optional)
Disassemble the switch housing from the light
kit, you can keep the light kit for future use.
Attach the plastic plug to the switch housing.
(Fig. 14)
Holding the switch housing under your fan,
snap the wire connection plugs together .
Install the switch housing to the mounting
plate with screws provided. (Fig. 14)
1.
2.
3.
4.
While holding the light kit assembly under
your fan, snap the wire connection plugs
together (Fig. 13).
Carefully push all wires back into the switch
housing, then install the light kit assembly onto
the mounting plate with 3 screws provided. Be
sure to tighten all screws. (Fig. 13)
Install 2 x 13 watts compact fluorescent bulbs
(included) into the light kit sockets.
NOTE:
CFL bulbs are NOT dimmable.
Remove the metal nut, glass cap and decorative
nut from the light kit. Place glass shade over
the light kit stem, secure with the metal nut
(rubber side on the top), glass cap and decora-
tive nut. Do not overtighten (Fig. 13).
Insert the 2 pull chain through the eyelet in the
shade and cap. Secure the glass cap and
decorative nut provided (Fig. 13).
Restore power and your light kit is ready for
operation.
1.
2.
3.
4.
5.
6.
Figure 13
Figure 14
NOTE
LIGHT BULBS HAVE NO WARRANTY; CAN BE
PURCHASED AT ANY HOME DEPOT STORE.
NOTE
MAKE SURE TO LEAVE ENOUGH SPACE
BETWEEN THE FAN PULL CHAIN AND THE
BULBS SO THE CHAIN DOESN'T RUB AGAINST
ANY OF THE BULBS.
CAUTION
BEFORE STARTING INSTALLATION, DISCONNECT
THE POWER BY TURNING OFF THE CIRCUIT
BREAKER OR REMOVING THE FUSE AT FUSE
BOX. TURNING POWER OFF USING THE FAN
SWITCH IS NOT SUFFICIENT TO PREVENT
ELECTRIC SHOCK.
Screws
Pull Chain
Glass
Shade
Bulbs
Light Kit
Assembly
Glass Cap
Metal Nut
Decorative Nut
Mounting Plate
Wire Connection
Plugs
Screws
Switch
Housing
Mounting Plate
Wire Connection
Plugs
Plastic Plug
Installing the
Light Kit
