12
Attaching the blades to the blade
brackets
2
☐
Mount the fan blade (G) to the blade bracket (H) by
aligning the three key-slot holes in the blade (G) with the
three posts on the top of the blade bracket (H).
☐
Hold the blade (G) with both hands close to the blade
bracket (H) and press down firmly. Ensure the key-slot
holes are properly seated on the blade bracket (H) posts.
☐
While still holding the blade (G) down with both hands,
slide the blade (G) until it engages in the locking
mechanism (UU). Make sure the locking mechanism
(UU) at the rear of the blade bracket (H) springs upward
and butts against the edge of the blade (G), indicating a
secure connection.
☐
Visually inspect the top of the blade bracket (H) to ensure
the locking mechanism is securely in place.
☐
Repeat this procedure for the remaining blades (G).
Assembly - Attaching the Fan Blades
Fastening the blade brackets to
the motor
1
☐
Fasten the blade brackets (H) to the fan-motor assembly
(E) by inserting the alignment post into the slot on the
bottom of the motor and tightening the pre-installed blade
bracket screws by inserting a screwdriver through the
access hole (ZZ).
☐
Repeat this step for the remaining blade bracket by rotat-
ing the motor until the next blade bracket screw can be
accessed through the access hole (ZZ) in the switch cup
cover.
☐
Press back the water proof plug (GG) to the access hole (ZZ)
on the switch cup.
WARNING:
Remove the rubber motor stops on the
bottom of the fan before installing the blades or testing
the motor.
NOTE:
Your fan features revolutionary advancements for
quick and easy blade installation, including an alignment
post and captive blade bracket screws.
IMPORTANT:
The switch cup has an access hole (ZZ) to
allow the screwdriver to reach the screws in the blade
bracket. Position the blade bracket on the motor and tighten
by inserting the screwdriver through the access hole (ZZ).
H
E
ZZ
E
H
G
UU
